Plane Support can 3D-print the cabin air-conditioning ducts for McDermott Aviation's Bell 214B bushfire helicopters, after Australia's aviation regulator approved the parts.
Metal additive manufacturing relies on argon and nitrogen to keep oxygen away from hot, reactive metal. Those same gases can quietly lower the... read more »
ETH Zurich will 3D-print artificial molasse sandstone, with weak layers placed on purpose, to study why historic Swiss stone shells off.
FAMU-FSU engineers 3D printed wind-tunnel models of wave-shaped walls and roofs that cut peak wind pressure by 40% to 60%.
Meshy is the only AI 3D company on Andreessen Horowitz's (a16z) new Top 50 Consumer AI Apps by Monthly Revenue, the first time... read more »
Daniel Nilsson at Umeå University showed that a desktop 3D printer can make custom laboratory instruments for biological research.
TU Delft engineers 3D printed a short joint between stiff and flexible lattices, a step toward implants that connect hard tissue to soft... read more »
Revopoint's Fall into 3D Sale runs October 5 to 15 on the official store, with discounts from 10 to 40% across scanners, refurbished... read more »
The Amsterdam robotic metal printing company is the first in the world to hold DNV's highest additive manufacturing classification for wire arc additive... read more »
Harbin Institute of Technology researchers 3D-printed a cement supercapacitor whose interlocking electrodes store a charge while the piece still carries a structural load.
NTU researchers 3D-printed a gel bone scaffold that releases copper and an antibiotic quickly at first, then more slowly, so one implant can... read more »
Hands-on with the wireless Revopoint MetroY Pro, tested against the MetroX for speed, laser lines, structured light, and color textures.
University of Glasgow engineers, with colleagues at the University of Sydney, used a hospital imaging method to map cracks in 3D-printed lattice parts... read more »
Cranfield University researchers 3D-printed natural rubber gloves by spraying latex onto a mould, a process meant to replace the dipping lines glove factories... read more »
Prototal Group describes itself as Europe's leading manufacturing service provider for industrial 3D printing, injection molding and vacuum casting. With nine facilities in... read more »
Lawrence Livermore National Laboratory 3D-printed a bioreactor that uses bacteria in thin lattice walls to turn waste methane into succinate.
Snapmaker and hotend specialist Phaetus have launched the Liber High Flow Hotend for the Snapmaker U1 toolchanger. According to Snapmaker, it delivers up... read more »
City University of Hong Kong and the University of Cambridge have opened a joint centre that will use 3D printing for data-centre cooling... read more »
Oak Ridge National Laboratory and Boeing 3D-printed a nearly two-ton steel mold for stamping thermoplastic composite aircraft parts.
Lawrence Livermore mounted cameras on a direct-ink printer so software can measure filament diameter and flag broken strands before a part leaves the... read more »
