QIDI has launched the Q3D at Formnext 2026, a dual-nozzle 3D printer designed to make printing with two materials simpler.

Switching materials normally involves purging, in which the old filament is pushed out until the new one runs clean, and that costs time and plastic. The Q3D instead carries two hotends, each with its own nozzle, which can run at different temperatures and handle different materials. Because the extruder modules and filament paths are physically separate, the printer needs fewer purging steps and temperature changes when it switches, so less material goes to waste.
The primary hotend has a quick-release design and heats up to 350°C. Meanwhile, the toolhead is built to be light, which reduces the inertia of the moving parts. As a result, it vibrates less during fast moves, which helps against ghosting and ringing, the faint ripples that can appear next to sharp features on a print.
For the first layer, an eddy current sensor measures the build plate directly with the nozzle. That removes the need for an offset correction, so bed leveling should be more accurate. Linear guide rails then keep the motion smooth at high speed and acceleration, with less friction and wear over time.
Heat management gets just as much attention. A fourth-generation active chamber heater keeps the enclosure at up to 70°C, which reduces warping and cracking between layers and lets the Q3D handle engineering materials such as nylon (PA). At the same time, a dedicated cooling system blows air straight onto the extruder, and QIDI says this cuts the risk of heat-related clogs by up to 90%. A dual intake also pulls outside air into the chamber to cool fresh filament for cleaner overhangs and bridges.
Since QIDI also aims the Q3D at home users, the printer filters its own air. Its three-stage module combines a G3 pre-filter, an H12 HEPA filter and activated carbon to reduce odors and capture 99.5% of airborne particles and dust.
The Q3D is now available for pre-order through the official QIDI store. Visitors to Formnext in Frankfurt can see it in Hall 12.1 at booth E01 until November 20.
Source: QIDI via GlobeNewswire, QIDI on X









